Press and hold the power button for 3 seconds to reboot your wireless audio device.
Press and hold the power button for 10 seconds to reset your wireless audio device to factory settings and clear the network configuration.
Your wireless audio device will enter Standby Mode (reduced power consumption) after 20 minutes of no music playing. It will automatically wake-up when it senses music being received. The Power button will stay illuminated whether the unit is powered on or in Standby Mode. If there is a power failure while your wireless audio device is switched on, it will switch back on once power has been restored.
VOLUME UP / DOWN
Press once to turn volume up/down.
Press and hold to ramp the volume up/down.
Press and release to mute the MartinLogan wireless audio device. Pressing this button a second time or pressing either volume button will restore the previous volume setting.
If you are using ARC™ (Anthem Room Correction) press and hold the mute button for 5 seconds to turn off ARC on/off. A ‘negative tone’ will sound to verify ARC is switched off. A ‘positive tone’ will sound to verify ARC is switched on.
Switches to the rear panel analog input. This button illuminates white when streaming mode is enabled and blue when the analog input is enabled. If the wireless audio device is set to analog input and detects a new audio stream, it will automatically switch to streaming mode.
WI-FI INDICATOR LIGHT
The Wi-Fi Indicator tells you what your wireless audio device is doing.
Rapid Blinking: booting up.
Blinking: connecting to a wireless router.
Slow Pulse: Access Point Setup Mode.
Two Blinks & Pause: WPS (Wi-Fi Protected Setup) Mode.
Solid: Connected to a wireless router.
Off: Connected to a router via Ethernet.
The rear of the Bravado speaker features a switch that allows you to customize the output of the speaker for specific applications. If the Bravado is being used for stereo output, set this switch to “stereo”. If a stereo pair of the speakers are being used in a 2-channel application, set the switch to “left” or “right” depending on the speaker position. Please note, newer versions of the DTS Play-fi app allow you to configure two speakers to function as a stereo pair. When doing this the position switch should be set to stereo to allow the DTS app to control left/right output.
WI-FI SETUP BUTTON (REAR PANEL)
Pressing this button puts the Bravado into wireless setup mode. Please refer to the user’s manual for setup information.